USED YAMAHA / SC-1200 Super Combinator Stain [11]

Highest model of SC series released in 1977.
Maple, mahogany, and alder body with maple and mahogany 5-piece neck. Neck-through-body construction. Ebony fingerboard.
The neck-through-body construction makes the guitar highly playable even in the high position. Each of the three pickups has an ON-OFF-PHASE switch, providing 13 different sound variations.
The pegs are slightly sticking and hard. The neck is slightly wavy and has been fretted, but will need to be replaced at the next repair.
Please be careful not to insert a wrench or other rod too far into the slot in the truss rod, as it will interfere with the internal wall surface and prevent it from turning.
The sound from the amp is acceptable, although it is a little prone to chattering.
There is a crack on the fretboard, and there are some repair marks as if glue was put into the fretboard.
There are many dents on the body end and body corners with paint dents.
There are other minor scratches, small dents, and other signs of use.
Item Rank: B: Fairly scratched and used, but no problems in normal use.

Serial Number: 001468
Case: Non-authentic soft case
Weight: 3.70kg
Truss Rod: No problem, checked up to 60 degrees to the left and right (slightly wavy).
Fretboard: Defective, need to consider replacing next time for repair.
String height on bass string side: 2.0mm above 12th fret
String height on treble string side: 1.5mm above 12th fret
Nut width: 41.7mm
Neck thickness near 1st fret: 20.9mm
Neck thickness near 12th fret: 24.7mm
SCALE: 648mm (25.5")
RADIUS: 184mm (7.25")
Strings in setup: ERNIE BALL 2223 / .009-.042 set
Repair and maintenance: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, nut adjustment

* Please note that this is a used item and there may be scratches, dents, etc. that are difficult to see in the photos or that are not shown in the description. Please understand that there are scratches, dents, etc. that are difficult to see in the photos.

* If the truss rod, remaining frets, or string height is indicated, it was measured by our staff at the time of setup and may change due to climate, humidity, or other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.

Specs

Product rank
B: Fairly scratched and used, but no problem in normal use.

12 months old

Serial No.
001468

Case
Non-genuine soft case

Weight
3.70kg

Truss Rod
No problem (slight waviness)

Remaining frets
Defective, need to consider replacing the frets at the next repair

String Height Low String Side
2.0mm above the 12th fret

High string side
1.5mm above the 12th fret

Nut width
41.7mm

Neck thickness near 1st fret
20.9mm

Neck thickness near 12th fret
24.7mm

Scale
648mm (25.5")

RADIUS
184mm (7.25")

Strings for setup
ERNIE BALL 2223 / .009-.042 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, nut adjustment