USED FERNANDES / BO-50 VS [12]

This model is very rare as a Japanese vintage bass.
BO-50, which was listed in the catalog for only two years, 1980 and 1981, is now in stock.
This model is called "Ishi Nandes" because of the logo on the head.
This BO-50 is similar to the FPM-70 that was released at the same time, but this BO-50 has L-20D pickups with adjustable pole pieces.
The 5-piece maple/mahogany thru-neck construction with Sen used for the body wings.
It has a unique, sticky sound with an emphasis on bass.

The neck is set up at a higher string height due to its wavy and twisted condition.
The truss rod is movable, but the adjustment range is narrow and there is not much left to tighten.

There is a gap under the bridge due to the shrinkage of the body material and deformation of the bridge parts over time, but this does not hinder the performance.
There are large and small dents on the lower part of the body top and the body back, as well as minor scuffs and scratches throughout the body, and the metal parts are dull.
The paint around the truss rod adjustment port is slightly peeling.
The string height is high, but there is no fretting or sound clogging at present.

Item Rank: C+: Needs to be repaired depending on its intended use.

Year of manufacture: 1980-1981
Country of manufacture: Japan
Case: Non-authentic hard case
Weight: 3.78kg
Truss Rod: No problem, rod is 60 degrees to the left and right.
Fretboard: No problem, sufficient fretboard height.
String height on bass side: 3.0mm above 12th fret
String height on treble string side: 2.5mm above 12th fret
Nut width: 40.4mm
Neck thickness near 1st fret: 19.5mm
Neck thickness near 12th fret: 22.1mm
SCALE: 864mm (34")
RADIUS: 184mm (7.25")
Strings in setup: D'Addario EXL165 / .045-.105 set
Repair and maintenance: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, electrical repair

Specs

Product Rank
C+: Needs repair depending on intended use

12 months old

Year of manufacture
1980-1981

Country of manufacture
Japan

Case
Non-genuine hard case

Weight
3.78kg

Truss Rod
No problem (Not much left, torsion and waviness)

Fret Remaining
No problem, there is enough fret height

String Height Low String Side
3.0mm above 12th fret

String height on treble string side
2.5mm above the 12th fret

Nut width
40.4mm

Neck thickness near 1st fret
19.5mm

Neck thickness near 12th fret
22.1mm

Scale
864mm (34")

RADIUS
184mm (7.25")

Strings for setup
D'Addario EXL165 / .045-.105 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, electrical repair