USED P-PROJECT / ST-TYPE Cherry Sunburst [12]

P-PROJECT's ST type is now in stock.
This Kobe-based component guitar/bass brand produces high-end models for professional musicians, mainly made-to-order.

The model in stock this time is probably an order-made model, too. It has a ST-shaped body with a maple top and mahogany back, a thin C-shaped maple neck/ Ebony fingerboard with 22 frets, a near-flat fingerboard radius, and jumbo frets, which were common specs of other manufacturers in the mid to late 80's. The body is made of maple with a mahogany back. The specs are similar to those seen in the mid- to late-80's with a flat fretboard radius and jumbo frets.

The pickups are HOT front pickups and HOT LEAD center/rear pickups.
It is a covered but passive pickup with a flat sound quality characteristic that can be used in a wide range of genres and styles with good compatibility with effects pedals.

It has special controls such as master volume, low-cut tone (effective only when the push/push switch is on), and master tone (the front PU sounds when the push/push switch is on and the center PU is in the selector position). The body has a large peeling of paint on the end.
There is a large paint peel on the end of the body and a chip on the tip of the horn on the 6th string side.
There is a large paint crack at the neck joint, but it does not affect the wood.
The pickguard has been replaced, as there are some machining marks on the pickguard where it meets the bridge, and some of the holes do not line up with the screw holes on the body side.
There are also minor scratches and dings throughout, and the hardware is dull.
Although there is a slight feeling of use, each part has been maintained and cleaned at our repair center, and playability is good.
The back panel and arm are missing.
Item Rank: B+: Some scratches, but no problems in normal use.

Case: Non-genuine soft case
Weight: 3.91 kg
Truss Rod: No problem, rod is verified to 60 degrees to the left and right.
Fretboard Height: No problem, fretboard height is high enough.
String height on bass side: 2.0mm above 12th fret
String height on treble string side: 1.5mm above 12th fret
Nut width: 42.0mm
Neck thickness near 1st fret: 20.0mm
Neck thickness near 12th fret: 22.3mm
SCALE: 648mm (25.5")
RADIUS: 356mm (14")
Strings in setup: ERNIE BALL 2223 / .009-.042 set
Repair and maintenance: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment

* This is a used item and there are scratches, dents, etc. that are difficult to see in the photos or other than those listed. Please understand that there are scratches, dents, etc. that are difficult to see in the photos.

* If the truss rod, remaining frets, or string height is indicated, it was measured by our staff at the time of setup and may change due to climate, humidity, or other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.