USED Fender Japan / JG66-98D 3-Tone Sunburst [05]

Fender Japan's JG66-98D is now in stock.

This model was produced in the 2000s as a music store order. The serial number indicates that this model was produced between 2002 and 2004.

The pickups are made from 1966 Jaguar with Dimarzio humbuckers, and the controls are made with a special plate and toggle switch.
The bridge is a tune-o-matic, and the guitar was made as a K.C. specification model.

Each neck pocket is stamped "DK203" to confirm that the body and neck are definitely original, and the neck side is stamped "JG" and the body side is stamped "JG66-98D" although some of the stamps are faded.

The guitar has some scratches and dents, but it has been checked and adjusted by a professional repair person since its arrival, and is in good playing condition.

Comes with genuine soft case and arm. * The zipper on the soft case pocket is damaged.

SPEC

Body: Alder
Neck: Maple
Fingerboard: Rosewood
Scale: 24"
Neck Joint: Bolt-On
Pickups: (Neck)Dimarzio PAF(Bridge)Dimarzio Super Distortion
Controls: Vol,Tone,Preset SW(Vol. Tone),PU On/Off SW,lo-Cut SW

Item Rank: B+: Some scratches, but no problems in normal use.

Serial Number: Q011194
Year of manufacture: 2003
Country of manufacture: Japan
Case: Non-authentic soft case
Accessories: Arm
Weight: 3.8kg
Truss Rod: No problem, rod is 60 degrees to the left and right.
Fretboard Height: No problem, fretboard height is sufficient.
String height on bass side: 2.0mm above 12th fret
String height on treble string side: 1.5mm above 12th fret
Nut width: 38.7mm
Neck thickness near 1st fret: 20.9mm
Neck thickness near 12th fret: 23.6mm
SCALE: 610mm (24")
RADIUS: 241mm (9.5")
Strings in setup: ERNIE BALL 2221 / .010-.046 set
Repair and maintenance: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, fret adjustment

* The truss rod, remaining frets, and string height are measured by our staff at the time of setup and may vary due to differences in climate, humidity, and other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.

Specs

Product Rank
B+: Some scratches, but no problem in normal use.

12 months old

Serial No.
Q011194

Year of manufacture
2003

Country of manufacture
Japan

Case
Non-genuine soft case

Accessories
Arm

Weight
3.8kg

Truss Rod
No problem, rod is fine, checked up to 60 degrees to the left and right.

Fret Remaining
No problem, there is enough fret height

String Height Low String Side
2.0mm above 12th fret

String height on treble string side
1.5mm above the 12th fret

Nut width
38.7mm

Neck thickness near 1st fret
20.9mm

Neck thickness near 12th fret
23.6mm

Scale
610mm (24")

RADIUS
241mm (9.5")

Strings for setup
ERNIE BALL 2221 / .010-.046 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, fret adjustment