USED Tom Anderson / Drop Top Quilted Maple Top Floyd Burnished Orange Burst with Binding 2010 [10]

2010 drop top with non-pickguard in stock!

Basswood is used for the body back which is tonewood. This tonewood is also loved by the S company, as it has few peculiarities and outputs the PU's character honestly. The neck is made of hard rock maple with a rosewood fingerboard. Neck joint is "A Wedgie joint system" which has been adopted since 2006. The neck shape is "Even Taper", which is relatively thin. Nut width is about 43mm. Of course, "Buzz Feiten Tuning System" is equipped for natural sound. The frets are original stainless steel and thick "Heavy" frets.

The front and center PUs are original "SC1" with hum canceling structure and a little stronger output than vintage sound. The rear PU is an original H3. The low end is tight and the high and midrange are emphasized by the ceramic magnet. The DC resistance value is approximately 14k as announced by the manufacturer. Controls are 5-way, M Vol, M Tone, and a mini-switch for series, parallel, or split switching of each PU. Pulling the tone knob mixes the front and rear PUs when front and center, and "Pull Adds Bridge" is used. The original version was equipped with VA Boost, but it has been changed to a Sillipara switch.

There are scratches, scuffs, and dings on the body, and there is a fine cloudy picking scratch on the right side of the PU. The upper left side of the PU on the neck side is dotted with pick tip scratches. There are dents on the lower right and upper left edges of the top of the body. There is a ding on the tip of the cutaway on the outside of the 6th string, and a scratch on the opposite tip of the cutaway on the outside of the 1st string. The paint on the side of the neck on the 1st string is deteriorated due to use. There are dents and scratches on the lower edge of the body back. There is a small toe scratch on the upper back of the body around the bottom of the joint screw. The back of the neck has a satin finish, but it is shiny from use. There is also a scratch on the tip of the head. The Floyd Rose has a Hollow Point intonation system installed, and each insert block has been replaced. The rear PU has the usual flexing, but it is in good working order. The pole piece and mounting screws have deteriorated due to use. The back panel is missing.

The neck is in good condition, and the truss rod can be tightened or loosened. There are no noticeable string marks on the frets, and about 80% of the frets are left. The current string height is about 2.0mm on the 12F 6th string side, and about 1.5mm on the 1st string side.

The guitar has been cleaned and is clean, although it has an energetic feeling of use. There is no noticeable damage to the top of the body, which is the face of the instrument.

Weight 3.38kg
Neck condition is fine.
Adjustable truss rod can be tightened or loosened.
About 80% frets remaining.
Country of originMade in USA
CaseNon-genuine hard case (* Fender DLX Molded Case)
AccessoriesTremolo arm
Item rank B+: Some scratches, but no problem in normal use.
Serial number 08-20-10N