USED Fender Japan Fender Japan / ST650SPL Torino Red [20]

This is a special limited edition model with an American Standard bridge, made at the Fujigen factory.
While a part of the manufacturing process of the American Standard made in the USA starting in 1986 was carried out in Japan, it is said that the parts were appropriated and this model was born, which is very valuable nowadays.
With an alder body, American Standard bridge, and bi-flex truss rod, this is a practical model that would become a forerunner to the later prosperity of modern Strats.
The pickups have been replaced with Lace Sensor by Lace Pickups.

* After our arrival, it has been cleaned, string replaced, rod adjusted, octave adjusted, string height adjusted, rubbed, nut adjusted, and electrical cleaned, so it is in good playing condition.

There are some signs of use such as minor scratches and small dents.

Item rank: B+ (Good)

Year of manufacture: 1987-1988
Truss rod: There is enough room.
Fret: 60-70%.
Accessories ： Soft case / Non genuine arm
Country of Origin ： Japan
Weight ： 3.67kg
Serial ： MIJ G014121

Truss Rod: No problem, confirmed up to 60 degrees left and right
Fret height is sufficient.
String height(bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|42.6mm
Neck thickness(near 1st fret)|20.4mm
Neck thickness (near 12th fret)|21.8mm
SCALE|648mm (25.5")
RADIUS|241mm (9.5")
Strings in setup|ERNIE BALL 2223 / .009-.042 set
Repair and maintenance parts|cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, mortise and tenon adjustment, nut adjustment, electrical cleaning

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a one-of-a-kind item.
We will try to delete the product information as soon as possible, but it is not always in real time.

specs&nbspSpecs

Truss Rod
No problem, rod is confirmed to be 60 degrees to the left and right.

Remaining frets
No problem, there is enough fret height.

String height (bass string side)
2.0mm above 12th fret

String height (treble string side)
1.5mm above 12th fret

Nut Width
42.6mm

Neck Thickness (near 1st fret)
20.4mm

Neck Thickness (near 12th fret)
21.8mm

Scale
648mm (25.5")

RADIUS
241mm (9.5")

Strings for setup
ERNIE BALL 2223 / .009-.042 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, nut adjustment, electrical cleaning