USED SCHECTER Schecter / Progauge Series PS-S-ST [20]

This is a Schecter ST type guitar manufactured in the U.S. and Japan as a component guitar.
It has a beautifully grained 2P ash body and rose fretboard, as is typical of Schecter, and the controls are a little different, with a connection of 1Vo / 1To and a low cut.
The low cut knob can be tapped by push-pull.
The pegs have been replaced and there is a hole on the pickguard where a guitar synth was attached.

* The guitar has been cleaned, string replaced, rod adjusted, octave adjusted, string height adjusted, and fret grated after our arrival, so it is in good playing condition.

There are many fine scratches and small dents in the wood, and there is a sense of use.

Item rank: B+ (Good)

Year of manufacture: 2013
Truss rod: There is enough room.
Fretboard: 60-70%.
Accessories ： Soft case / Non-genuine arm
Country of Origin ： Japan
Weight ： 3.63kg
Serial ： SW131204

Truss Rod: No problem, confirmed to be 60 degrees to the left and right
Fret height is sufficient.
String height(bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|42.2mm
Neck thickness(near 1st fret)|20.3mm
Neck thickness (near 12th fret)|22.5mm
SCALE|648mm (25.5")
RADIUS|241mm (9.5")
Strings in setup|ERNIE BALL 2221 / .010-.046 set
Repair and maintenance parts|Cleaning, string change, rod adjustment, octave adjustment, string height adjustment, fret adjustment

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a one-of-a-kind item.
We will try to delete the product information as soon as possible, but it is not always in real time.

specs

Truss Rod
No problem, rod is confirmed to be 60 degrees to the left and right.

Fret Remaining
No problem, there is enough fret height.

String height (bass string side)
2.0mm above 12th fret

String height (treble string side)
1.5mm above 12th fret

Nut Width
42.2mm

Neck Thickness (near 1st fret)
20.3mm

Neck Thickness (near 12th fret)
22.5mm

Scale
648mm (25.5")

RADIUS
241mm (9.5")

Strings for setup
ERNIE BALL 2221 / .010-.046 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, fret adjustment