USED YAMAHA Yamaha / SA-2000S Burgandy Red [20]

With carefully selected woods and meticulous finishing, you can feel the elegance of this top-of-the-line model of the SA series.
The original humbuckers installed on this guitar are characterized by their grainy sound and respond to the perfection of the player.

* After our arrival, cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, and electrical repair have been done.
The neck is slightly wavy and has been adjusted by mortising.
The frets are quite low, but the tuning can be done without sound jamming.

The gold parts have some spots, minor rusting, and peeling of plating.
There are many small dents on the top of the body with paint cracks and dents, and overall, there are some minor scratches and small dents.
There are many stickers on the hard case, and the exterior of the case is peeling.

Item rank: B+ (Good)

Truss rod : There is enough room.
Fret : Less than 50%.
Accessories ： Hard case / Genuine
Country of Origin ： JAPAN
Weight ： 3.81kg
Serial ： 058805

Truss rod: No problem (slight waviness)
Fret remainder is defective and needs to be replaced when it is repaired next time.
String height (bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|42.9mm
Neck thickness(near 1st fret)|20.6mm
Neck thickness (near 12th fret)|24.9mm
SCALE|628mm (24.75")
RADIUS|356mm (14")
Strings in setup|ERNIE BALL 2221 / .010-.046 set
Repair and maintenance parts|cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, mortise and tenon adjustment, electrical repair

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a single item.
We will try to delete the product information as soon as possible, but it is not always in real time.

specs

Truss Rod
Note: We have checked the rod up to 60 degrees to the left and right, and there is no problem.

Fret remainder
Defective, need to consider replacing the frets at the next repair

String height (bass string side)
2.0mm above the 12th fret

String height (treble string side)
1.5mm above the 12th fret

Nut width
42.9mm

Neck Thickness (near 1st fret)
20.6mm

Neck Thickness (near 12th fret)
24.9mm

Scale
628mm (24.75")

RADIUS
356mm (14")

Strings for setup
ERNIE BALL 2221 / .010-.046 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, electrical repair