USED TOM ANDERSON / Drop Top Quilt Floyd Rose [10]

Special price for long-term store display items!
2010 drop-top with non-pickguard is in stock!

Basswood is used for the body back which is tonewood. This tonewood is also used by the S company, and has few peculiarities and outputs the PU's character honestly. The neck is made of hard rock maple with a rosewood fingerboard. Neck joint is "A Wedgie joint system" which has been adopted since 2006. The neck shape is "Even Taper", which is relatively thin. Nut width is about 43mm. Of course, "Buzz Feiten Tuning System" is equipped for natural sound. The frets are original stainless steel and thick "Heavy" frets.

The front and center PUs are original "SC1" with hum canceling structure and a little stronger output than vintage sound. The rear PU is an original H3. The low end is tight and the high and midrange are emphasized by the ceramic magnet. The DC resistance value is approximately 14k as announced by the manufacturer. Controls are 5-way, M Vol, and M Tone, with a mini-switch for series, parallel, and split switching of each PU. Pulling the tone knob mixes the front and rear PUs when front and center, and "Pull Adds Bridge" is used. The original version was equipped with VA Boost, but it has been changed to a Sillipara switch.

There are scratches, scuffs, and dents on the body. Hollow Point intonation system has been installed on the Floyd Rose, and each insert block has been replaced. The back panel is missing.

The neck is in good condition, and the truss rod can be adjusted to tighten or loosen. There are no noticeable string marks on the frets, and about 80% of the frets are left. The current string height is about 2.0mm on the 12F 6th string side, and about 1.5mm on the 1st string side.

The guitar has been cleaned and is clean, although it has an energetic feeling of use. There is no noticeable damage to the top of the body, which is the face of the instrument.

Weight 3.38kg
Neck condition is fine.
Adjustable truss rod can be tightened or loosened.
About 80% frets remaining.
Country of originMade in USA
CaseNon-genuine hard case (* Fender DLX Molded Case)
AccessoriesTremolo arm
Item rank B+: Some scratches, but no problem in normal use.
Serial number 08-20-10N

Item rank: B+: Some scratches, but no problem for normal use

Accessories: Tremolo arm

* Due to the used nature of this item, there may be scratches, dents, and other blemishes that are difficult to see in the photos or that are not listed in the description. Please note that there are scratches, dents, etc. that are difficult to see in the photos.

* The truss rod, remaining frets, and string height are measured by our staff at the time of setup, and may change due to climate, humidity, and other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.