USED YAMAHA / Pacifica Custom YNS [12]

The YAMAHA / Pacifica Custom is now in stock!
The Pacifica series continues to enjoy widespread popularity even today.
This is the Pacifica Custom, the top-of-the-line model from the 1990s.
It was developed with the concept of creating the ultimate bolt-on guitar.

It was designed at Yamaha’s development facility in California and marketed as a guitar with world-class design.
The body and neck are from Warmoth, a U.S. company renowned for its replacement bodies.
The woodworking is exceptionally precise, and the finish is applied lightly, allowing for a rich, resonant low-end tone despite the bolt-on construction.

With its beautiful curly maple top and mahogany back—whose grain feels pleasant to the touch—it boasts the classic look of a high-end ’90s guitar.

It is a timeless masterpiece that remains in active use even today.
The pots and switches appear to have been replaced as well.

The pickups have been swapped from Dimarzio to Seymour Duncan (front: APH-1N, middle: SSL-6, bridge: TB-11).

The neck shows some twisting and warping, which has been corrected through leveling.
As a result of the leveling, the height at the final fret on the G-string side has been reduced to about 30% of its original height, but it is still playable.
We will need to consider replacing it during the next repair.

Although not very noticeable, there are scattered dents on the body.

Overall, there are scattered fine scratches and dents, and the hardware shows some tarnish.
Although it shows some signs of use, it has been fully serviced and cleaned at our repair center, and playability is good.
Condition Grade: B+: Some minor scratches, but no issues for normal use

Serial Number: C 503008
Case: Genuine hard case
Accessories: Tonearm
Weight: 3.99 kg
Truss Rod: Tested to 60 degrees in both directions; no issues (slight twisting and waviness present)
Fret Wear: Still playable but frets are on the low side
String height (low-string side): 2.0 mm at the 12th fret
String action (treble side): 1.5 mm at the 12th fret
Nut width: 43.4 mm
Neck thickness near the 1st fret: 17.7 mm
Neck thickness near the 12th fret: 20.4 mm
Scale: 648 mm (25.5")
Radius: 254 mm (10")
Strings at Setup: ERNIE BALL 2223 / .009-.042 set
Repairs and Maintenance Performed: Cleaning, string replacement, truss rod adjustment, octave adjustment, action adjustment, fret leveling, electronics repair

* As this is a used item, there may be scratches, dents, and other imperfections that are not clearly visible in the photos or not listed here. Please be aware of this in advance.

* Any listed measurements for the truss rod, remaining fret height, string action, etc., were taken by our staff during setup and are subject to change due to environmental factors such as climate and humidity.
These measurements are intended as a reference at the time of purchase; we cannot guarantee that the measurements will be identical when the item arrives at your location.

* This is a one-of-a-kind item that is listed simultaneously on multiple marketplaces, including our in-store display. We strive to remove product listings promptly upon sale, but updates may not always be in real time.
We sincerely apologize in the unlikely event that the item is sold out after you place your order, and we ask for your understanding.