USED Fender Japan Fender Japan / ST650SPL 3Tone Sunburst [20]

This is a special limited edition model with an American Standard bridge, made at the Fujigen factory.
While a part of the manufacturing process of the American Standard made in the USA starting in 1986 was carried out in Japan, it is said that the parts were appropriated and this model was born, which is very valuable nowadays.
With an alder body, American Standard bridge, and bi-flex truss rod, this is a practical model that would become a precursor to the later prosperity of the modern Strat.
The pickguard assembly has been replaced with American Deluxe N3 with S-1 Switch.

* After our arrival, it has been cleaned, string replaced, rod adjusted, octave adjusted, string height adjusted, rubbed, nut adjusted, and electrical cleaned, so it is in good playing condition.

The back plate is missing.
There is a small paint chip on the contour.
There are many dents with scratches and paint dents overall, and there is a sense of use.

Item rank: B+ (Good)

Year of manufacture: 1985-1986
Truss rod: There is enough room.
Fret: 60-70%.
Accessories ： Hard case / Non genuine arm
Country of Origin ： Japan
Weight ： 3.74kg
Serial ： A022059

Truss Rod: No problem, confirmed to be 60 degrees to the left and right
Fret height is sufficient.
String height(bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|43.5mm
Neck thickness(near 1st fret)|20.2mm
Neck thickness (near 12th fret)|22.0mm
SCALE|648mm (25.5")
RADIUS|241mm (9.5")
Strings in setup|ERNIE BALL 2223 / .009-.042 set
Repair and maintenance parts|cleaning, string change, rod adjustment, octave adjustment, string height adjustment

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a one-of-a-kind item.
We will try to delete the product information as soon as possible, but it is not always in real time.

specs&nbspSpecs

Truss Rod
No problem, rod is confirmed to be 60 degrees to the left and right.

Remaining frets
No problem, there is enough fret height.

String height (bass string side)
2.0mm above 12th fret

String height (treble string side)
1.5mm above 12th fret

Nut width
43.5mm

Neck Thickness (near 1st fret)
20.2mm

Neck Thickness (near 12th fret)
22.0mm

Scale
648mm (25.5")

RADIUS
241mm (9.5")

Strings for setup
ERNIE BALL 2223 / .009-.042 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment