USED Aria Pro II Aria Pro Two / PE-R60AB Antique Brown [20]

This is the PE Series PE-R60 from Aria Pro II (2), featuring Aria's world-class original shape, bold heel-less joint and arch top & flat back/body contour.
Maple top/mahogany back, heel-less set neck joint, maple neck, rose fingerboard, 14 degree head, medium scale, 2 x NEW EXTRA-III (MMK53) PU, dual sound SW each, SPT bridge & QH tailpiece. The neck is in good condition.

The neck is twisted and has a high spring symptom, and has been adjusted at the standard string height by fret adjustment and nut adjustment.

There are some parts with rust and scratches, and the plating is faded.
There are many dents on the back of the body due to the buckle, and there are overall signs of use such as line scratches and small dents.
The hard case that comes with the instrument has a lid that has shifted over time and does not close tightly.

After arrival, cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, electrical repair, mortise and tenon nut adjustment

Item rank: B+ (Good)

Year of manufacture: 1980
Truss Rod : Nearly fully tightened
Fretboard: 60-70% full
Accessories ： Hard Case / Genuine
Country of Origin ： Japan
Weight ： 4.28kg
Serial ： 012119

Truss Rod : No problem, confirmed up to 60 degrees left and right (with torsion)
Fret height is sufficient.
String height(bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|43.0mm
Neck thickness(near 1st fret)|19.7mm
Neck thickness (near 12th fret)|23.3mm
SCALE|628mm (24.75")
RADIUS|305mm (12")
Strings in setup|ERNIE BALL 2221 / .010-.046 set
Repair and maintenance parts|cleaning, string change, rod adjustment, octave adjustment, string height adjustment, electrical repair, mortise and tenon, nut adjustment

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a one-of-a-kind item.
We will try to delete the product information as soon as possible, but not necessarily in real time.

Specs

Truss rod is fine (with twist).

No fret remainder problem, enough fret height.

String height (bass string side): 2.0mm above the 12th fret

String height (treble string side) 1.5mm above 12th fret

Nut width 43.0mm

Neck thickness(near 1st fret)19.7mm

Neck thickness (near 12th fret)23.3mm

Scale628mm (24.75")

RADIUS305mm (12")

Strings at setup ERNIE BALL 2221 / .010-.046 set

Repair and maintenance partsCleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, electrical repair, mortise and tenon, nut adjustment