商品情報にスキップ
1 9

Verocity Effects Pedals / JVM-B2 Black Edition Marshall Distortion Overdrive [80]

Verocity Effects Pedals / JVM-B2 Black Edition Marshall Distortion Overdrive [80]

Item Code: 80-2100000664931
Condition: NEW
Store: [80]

通常価格 ¥46,762 JPY
通常価格 セール価格 ¥46,762 JPY
セール 売り切れ
配送料はチェックアウト時に計算されます。
If you would like to make a bank transfer, please give us an e-mail with name of your request item.
inquery
inquery
QQ: 3784816402
For customers residing in Japan
This product is a 3/4 channel emulator of Marshall JVM410, carefully assembled with hand-selected parts on a custom-layout PCB board, using BELDEN wires and high-grade mica capacitors, and packed in an MXR size. The size of this emulator reproduces the orange mode and red mode of the 3 and 4 channels of the JVM410 high gain channels while using the same EQ and volume.

Because it is a common EQ and volume, the Mid Shift constant needs to be selected between 3 and 4 channels, so a Mid Scoop mode (Don Shari), which is not available on the JVM34, can be added as a byproduct without modifying the circuit.

The faceplate and knobs are black in color, which differs from the standard specification!

ALT" (Adjustable Lead Trimer), which can be turned on and off with the slide switch next to the internal footswitch, makes it possible to attenuate the overall volume with the trimmer when Boost is off, thus enhancing the Boost sound. The internal trimmer can also be turned down to mute when Boost is off. It is recommended that the settings be set roughly by aural sensation. The effect is that when the Boost LED is lit, the sound will be loud.

To set up: 1. turn off Boost and set the volume to the desired position; 2. turn up the slide switch to get the trimmer effect; 3. check the volume difference while turning the slide switch on and off; 4. turn down the slide switch to get the trimmer effect; 5. turn down the slide switch to get the trimmer effect; 6. turn up the slide switch to get the trimmer effect; 7. * Operate the trimmer with extreme care to avoid applying excessive force. When the ALT is on, the lower LED will not turn off in conjunction with the trimmer when Boost is off in Bypass mode, but will light up at a low intensity. The higher the intensity, the lower the volume.

The Vero City High gain series is not designed to narrow the variable range in order to have unlimited sound possibilities. It is possible to design the pedal to suppress these oscillations, but this would significantly narrow the range of the sound. The oscillation is not a malfunction, as it is a noise and does not cause the unit to malfunction. Please be assured that it is not a cause of malfunction. When using high gain, noise that cannot be removed by design may be noticeable. In this case, we recommend adding a noise gate from another manufacturer immediately after the Emulation Pedal. The input jack can be unplugged to mute the unit (it does not turn off the power). The jack can be replaced without damaging the amplifier or speakers to which it is connected.

The output jack has a special function. When plugged in normally, the jack can be connected to the clean channel of an amplifier.

By half-plugging it in, the impedance can be changed so that it can be connected to the Return of a guitar amplifier. Half-insertion can also be used to achieve impedance matching in switching systems. Please note that the half-insertion may be compatible with the amplifier and shield of each company, so please find the best setting by yourself. When half-plugged, it has outputs corresponding to the Send output (bottom) and the Preamp output (top) of the JVM410. Please make the initial setting of the internal SW according to the connection destination.
Accessories: Box, Manual

* The image is a sample.
当製品は、一つ一つハンドセレクトされたパーツをカスタムレイアウトされたPCB基板に丁寧に組み上げ、BELDENワイヤー、高品位なマイカコンデンサを用いMXRサイズに収めたMarshall JVM410の3,4チャンネルのエミュレーターになります。この大きさで共通EQ,VolumeでありながらJVM410ハイゲインチャンネルの3,4chのオレンジモード,レッドモードを再現。

共通EQ,ボリュームとなるため、Mid Shift定数は3ch,4chの何れかの選択を取る必要がある事でJVM34には無いMid Scoop(ドンシャリ)モードを回路に手を加えずに副産物的に追加する事に成功。

通常仕様とは異なり、フェイスプレートとノブについてはブラックカラー仕様となっています!

☆内部フットスイッチ横スライドスイッチにてオンオフ可能な「ALT」(Adjustable Lead Trimer)。Boostオフ時の全体音量をTrimmerでアッテネートする事が可能となり、Boost時のサウンドをより強調する事が可能。内部トリマーを絞り切る事でBoostオフ時をMuteにする事も可能。セッティングについては、聴感上で大まかに設定する事をお勧めします。効果についてはBoost LEDが点灯している時にサウンドが大きく出力されます。

セッティング方法:1.Boostをオフにし使用するVolume位置に設定します。2.スライドスイッチを上にする事で、トリマーの効果が得られます。3.スライドスイッチをオンオフしながら音量差を確認します。* トリマーは大きな力を加えない様に細心の注意を払って操作願います。破損の場合は有償修理扱いとなります。4.ALTがオンの場合、Bypass状態Boostオフ時にて下段のLEDがトリマーと連動し消灯せず、低い光度で点灯します。光度が高いほど音量が低く設定されます。

Vero City High gainシリーズは、サウンドに無限の可能性を持たせるために、敢えて可変域を狭めるような製作を行っていないため、過度な設定における「ピーという発振」がコントロール調整によって音として現われることがございます。これらを抑える設計も可能ですが、著しくサウンドの幅を狭めてしまうことになり、Boutique Pedalならではの、ユーザーによる限界サウンドを追い求めることが可能な設計を施しております。発振については、本体の故障を招くものではなく、ノイズとして発しますので、故障ではございません。また、故障の要因となりませんので、ご安心下さい。また、ハイゲイン使用時には設計上削除できないノイズが目立つ場合がございます。この場合は、他社様のノイズゲートをEmulation Pedalの直後に増設する事をお勧めいたします。入力ジャックは、抜き去ることで本機のミュートが可能となります(電源は切れません)。接続先のアンプやスピーカーにダメージを与える事無くジャックの差し替えが可能となっております。

出力ジャックには、特殊な機能を設けております。通常の挿し方で、アンプのクリーンチャンネルに接続することが可能となります。

半挿しをする事で、ギターアンプのReturnに接続できるようなインピーダンス変更を可能としています。スイッチングシステム等で、インピーダンスの整合性を得るためにも半挿しを利用していただけます。半挿しについては各社アンプ及びシールドの相性がある場合がございますので、最良の設定についてはご自身で探して頂けますよう予めご了承下さい。半挿し時はJVM410のSend出力に相当する出力(下)、Preamp出力(上)に相当する出力を持っています。接続先に合わせて内部SWの初期設定をしてください。
付属品:箱、マニュアル

* 画像はサンプルです。

Payment and Shiping

Products are shipped from Japan after the order is processed, Shipping costs are calculated automatically at the checkout page when you select your destination. , Ship worldwide by Japan Post.

Founded in 1938, Ishibashi Music Corporation is one of the busiest and most respected Musical Instrument retail chains in Japan. The company is highly regarded world wide as a reliable seller of top quality secondhand items too. We have over 13 stores around Japan including Tokyo, Yokohama, Chiba, Nagoya, Osaka, Hiroshima,Fukuoka and Shanghai(China). Ishibashi Music Corporation also handles large amounts of NEW, USED and VINTAGE instruments.

詳細を表示する

Please Note

The items name with "USED" are used items, and comes as shown in the pictures so there may be marks of use. All items were tested by our store staff and we test each item one more time before shipping them out to make sure they are fully functional.

All items for sale on ISHIBASHI MUSIC are stock currently available from all of ISHIBASHI stores around Japan. So it might take a few days for shipping.

And there is a chance that they may sell out in our retail location beforehand.

In that case we will cancel the order and refund any payments received.

Buyers are responsible for any and all duty and customs charges that may be incurred.These charges are are not included in the item price or shipping charges.

Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying.

These charges are normally collected by the delivering courier company or when you pick the item up.

We are sorry, but we cannot alter the product price upon shipping nor can we call your purchase a gift.

If you want to know about tariff, please consult Customs.

Our business days are from Monday to Friday. We do not ship products on the weekends.

PACKING BOX SIZES

ABOUT US

Ishibashi Music Corporation is one of the largest and most respected Musical Instrument retail chain stores in Japan. The company is highly regarded world wide as a reliable seller of top quality USED and VINTAGE instruments.

Domestically the Ishibashi Music Corporation also handles a large amount of NEW inside of Japan. We have over 11 stores around Japan including Tokyo, Yokohama, Chiba, Nagoya, Osaka, and Fukuoka. Not all of the items you purchase from us are in our Shibuya store in Tokyo where we do all of our international communications from.

Please be patient while we do inter-company transfers on your items. The usual wait time for our shipping is 7 to 10 days worldwide. We are open from 10:00am until 6:00pm (Tokyo time zone)

Sale

1 4