USED Edwards / E-AMAZE-AS-5/M Solid Burner [11]

Cost-effective Japanese-made 5-string active bass.
Beautiful ash body with burnished finish, bolt-on maple neck with binding. Specially designed ESP CL-P-J5-2 pickups are installed.
The master volume is a switch pot that can be switched between active mode and passive mode by pulling up the knob. The outermost two knobs are dual-axis knobs, the inner one for treble and the outer one for bass boost and cut. Mid and gain can be adjusted with the trimmer inside the cavity. Tone also works, allowing for even finer adjustment.
In passive mode, the 2-axis knob is canceled. The tone section can be switched between two different capacitors of 0.022μF and 0.047μF, and the knob can be pulled up to make the tone more mildly effective.
This is a high-cost-performance model with a high level of perfection that can withstand professional use, but at an affordable price range.
The string bushing on the 5th string has been replaced.
There is a screw hole under the front pickup where a finger rest was installed.
There is a scratch on the pickguard. There is a small clear paint chip near the back panel. There are other light scratches and dings throughout, and some signs of use.
The neck is slightly twisted, but has been cleaned, string replaced, rod adjusted, octave adjusted, string height adjusted, and mortised, so there are no problems with playing condition.
Item Rank: B: Fairly scratched and used, but no problems in normal use.

Serial Number: ED8402233
Case: Non-authentic soft case
Weight: 4.57kg
Truss Rod: No problem, rod is fine, checked up to 60 degrees to the left and right.
Fret Height: No problem, fret height is sufficient.
String height on bass side: 2.7mm above 12th fret
String height on treble string side: 2.0mm above 12th fret
Nut width: 46.0mm
Neck thickness near 1st fret: 21.0mm
Neck thickness near 12th fret: 24.5mm
SCALE: 864mm (34")
RADIUS: 305mm (12")
Strings in setup: D'Addario EXL170-5 / .045-.130 set
Repair and maintenance parts: cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, sticker removal (under neck plate)

* The truss rod, remaining frets, and string height are measured by our staff at the time of setup and may vary due to differences in climate, humidity, and other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.

Specs (Japanese only)

Product rank
B: Fairly scratched and used, but no problem in normal use.

12 months old

Serial No.
ED8402233

Case
Non-genuine soft case

Weight
4.57kg

Truss Rod
No problem, rod is confirmed to be 60 degrees to the left and right.

Fret Remaining
No problem, there is enough fret height

String Height Low String Side
2.7mm above 12th fret

String height on treble string side
2.0mm above the 12th fret

Nut width
46.0mm

Neck Thickness near 1st Fret
21.0mm

Neck thickness near 12th fret
24.5mm

Scale
864mm (34")

RADIUS
305mm (12")

Strings for setup
D'Addario EXL170-5 / .045-.130 set

Repair and maintenance parts
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, sticker removal (under neck plate)