USED Navigator / Order JB Type See Through Red [12]

A good quality order JB type with a lot of attention to detail.
Although the official year is unknown, this is a Navigator made order JB type guitar probably made in the 80's. It has a moderately weighted 1 piece Sen body, a beautiful rosewood fingerboard, and a brass nut.

The sound is both sweet and smooth, with a one-piece Sen body of moderate weight, a beautiful rosewood fingerboard, and a brass nut, making it suitable for any player.

The controls are very simple (2Vo, 1Tone), which is also orthodox in a good sense.
The controls are simple, 2Vo, 1Tone, which is orthodox in a good sense, and can be played intuitively!

The body shows signs of use, and some parts are dull, but considering the age of the instrument, it appears to be relatively clean.
The truss rod has a little room to tighten, but there are shims between the shims. The neck has been straightened and the frets have been adjusted by a professional maintenance department.
Item Rank: B: Fairly scratched and used, but no problems in normal use.

Country of manufacture: Japan
Case: Original hard case
Weight: 4.35kg
Truss Rod: No problem (not much left), rod is checked up to 60 degrees to the left and right.
Fret Height: No problem, fret height is high enough.
String height on bass side: 2.5mm above 12th fret
String height on treble string side: 2.0mm above 12th fret
Nut width: 39.5mm
Neck thickness near 1st fret: 21.0mm
Neck thickness near 12th fret: 24.5mm
SCALE: 864mm (34")
RADIUS: 1F:184mm (7.25") 12F:241(9.5")
Strings in setup: D'Addario EXL165 / .045-.105 set
Repair and maintenance parts: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, neck ironing, strap pin replacement

* Please note that this is a used item and there are scratches, dents, etc. that are difficult to see in the photos or that are not shown in the description. Please note that there are scratches, dents, etc. that are difficult to see in the photos or that are not listed.

* If the truss rod, remaining frets, or string height is indicated, it was measured by our staff at the time of setup and may change due to the effects of climate, humidity, and other environmental differences.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.

Specs

Product Rank B: Fairly, there are scratches & feeling of use, but no problems in normal use

Country of manufacture Japan

CaseGenuine hard case

Weight 4.35kg

Truss rod rod is checked to 60 degrees left and right, no problem.

Fret height: The frets are high enough.

String height: 2.5mm above the 12th fret on the bass string side

String height: 2.0mm above the 12th fret on the treble string side

Nut width 39.5mm

Neck thickness near 1st fret 21.0mm

Neck thickness near 12th fret 24.5mm

Scale864mm (34")

RADIUS1F:184mm (7.25") 12F:241(9.5")

Strings D'Addario EXL165 / .045-.105 set at setup

Repair and maintenance parts cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, mortise and tenon adjustment, neck ironing correction, strap pin replacement