USED Fernandes Fernandes / TE-120S HT HOTEI Model [20]

Basswood body with original taping pattern paint, maple neck, J-type concord head, rose fretboard, "TOMOYASU HOTEI" truss rod cover, roller nut, full mode sustainer rear with original humbucker & front Sustainer unit, 1Vol/sustainer control, 2-point tremolo.

* After our arrival, cleaning, string replacement, rod adjustment, octave adjustment, and string height adjustment have been done.
There is a crack on the 6th string side of the neck joint, which has been reinforced by gluing.
The bridge stud anchors and the body were in a state where they were loose and would float, so they have been reinforced with glue.
The hole for the bridge saddle height adjusting screw seems to have widened due to deterioration.
The setting is now set at the standard value.
The battery snap has been replaced.

The back panel is missing.
There is a ding with a paint chip on the back side of the top of the head and a crack in the paint at the neck joint.
There are dents with paint cracks near the top corner controls and other corners of the body.
There are dents with cracks in the wood at the corners of the body back, and there are numerous dents with paint cracks and chips on the sides and back of the body as a whole.
There are other minor scratches and dents that show signs of heavy use.

Item rank: B+ (Good)

Truss rod: There is enough room.
Fret: 60-70%.
Accessories: Soft case / Non-genuine tremolo arm
Country of Origin ： Japan
Weight ： 3.65kg
Serial ： No serial number

Truss Rod : No problem, confirmed up to 60 degrees left and right
Fret height is sufficient.
String height(bass string side)|2.0mm above 12th fret
String height(treble string side)|1.5mm above 12th fret
Nut width|42.0mm
Neck thickness(near 1st fret)|20.9mm
Neck thickness (near 12th fret)|22.0mm
SCALE|648mm (25.5")
RADIUS|305mm (12")
Strings in setup|ERNIE BALL 2223 / .009-.042 set
Repair and maintenance parts|cleaning, string change, rod adjustment, octave adjustment, string height adjustment

* The truss rod, remaining frets, string height, etc. are the setting values at the time of setup and adjustment at our repair center.
* This item is only available as a one-of-a-kind item.
We will try to delete the product information as soon as possible, but it is not always in real time.

specs

Truss Rod
No problem, rod is confirmed to be 60 degrees to the left and right.

Remaining frets
No problem, there is enough fret height.

String height (bass string side)
2.0mm above 12th fret

String height (treble string side)
1.5mm above 12th fret

Nut Width
42.0mm

Neck Thickness (near 1st fret)
20.9mm

Neck Thickness (near 12th fret)
22.0mm

Scale
648mm (25.5")

RADIUS
305mm (12")

Strings for setup
ERNIE BALL 2223 / .009-.042 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment