USED FERNANDES / ARS-850S Polar White [11]

Fernandez ARS-850S with full mode sustainer.
The body is lightweight basswood, the neck is maple, and the fingerboard is rosewood.
Despite its 3-single look, the center and rear pickups are TB-1 and TB-2 with humbucking construction. The TB-1 and TB-2 pickups are humbucking, and the TB-1 and TB-2 are used for a wide range of sounds, from warm and tight drive sounds to supple clean tones.
The tuners made by Gotoh and the Wilkinson bridge provide excellent tuning stability and can handle aggressive arming.
The pickguard and control knobs have probably been replaced.
There is a repair mark near the contour on the left side of the body. Paint is cracked at the neck joint.
Overall, there are scratches, dents, and rust on the metal.
The neck is slightly twisted, but the frets have been fretted and there are no problems with normal use.
Item Rank: B: Fairly scratched and worn, but no problems with normal use.

Case: Non-genuine soft case
Accessories: Arm
Weight: 3.15kg
Truss Rod: No problem, rod is fine, checked up to 60 degrees to the left and right
Fretboard Height: No problem, fretboard height is sufficient.
String height on bass side: 2.0mm above 12th fret
String height on treble string side: 1.5mm above 12th fret
Nut width: 42.2mm
Neck thickness near 1st fret: 20.5mm
Neck thickness near 12th fret: 22.5mm
SCALE: 648mm (25.5")
RADIUS: 356mm (14")
Strings in setup: D'Addario EXL110 / .010-.046 set
Repair and maintenance parts: Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, control cleaning

* Please note that this is a used item and there may be scratches, dents, etc. that are difficult to see in the photos or that are not shown in the description. Please understand that there are scratches, dents, etc. that are difficult to see in the photos or that are not listed.

* If the truss rod, remaining frets, or string height is indicated, it was measured by our staff at the time of setup, and may change due to climate, humidity, or other environmental factors.
The values are intended to be used as a reference at the time of purchase, and we do not guarantee that they will be the same when you receive the instrument.

* This item is a one-of-a-kind item and is listed on multiple malls at the same time, including in-store displays. We try to delete product information as soon as possible, but this is not always in real time.
We apologize in advance if the item is sold out after you place your order.

Specs

Product rank
B: Fairly scratched and used, but no problem in normal use.

12 months old

Case
Non-genuine soft case

Accessories
Arm

Weight
3.15kg

Truss Rod
No problem, rod is fine, checked up to 60 degrees left and right.

Fret Remaining
No problem, there is enough fret height

String Height Low String Side
2.0mm above 12th fret

String height on treble string side
1.5mm above the 12th fret

Nut width
42.2mm

Neck thickness near 1st fret
20.5mm

Neck thickness near 12th fret
22.5mm

Scale
648mm (25.5")

RADIUS
356mm (14")

Strings for setup
D'Addario EXL110 / .010-.046 set

Repair and maintenance
Cleaning, string replacement, rod adjustment, octave adjustment, string height adjustment, rubbing, control cleaning